PLANET ADE-3400 - Manual (Page 45)

Field Description
Delete Selected
Select a row in the Static Route T able and click it to
delete the row.
Show Routes
Click it, the IP Route Table appears. You can view a list
of destination routes commonly accessed by your
network.
Static Route Table A list of the previously configured static IP routes.
Click Show Routes, the page shown in the following figure appears. The t able shows a
list of destination routes commonly accessed by your network.
3.6.2.2 RIP
Click RIP in the left pane, the page shown in the following figure appears. If you are using
this device as a RIP-enabled router to communicate with others using Routing Information
Protocol (RIP), enable RIP. This page is used to select the interfaces on your devices that
use RIP, and the version of the protocol used.
The following table describes the parameters and buttons of this page:
Field Description
RIP
Select Enable, the router communicates with other
RIP-enabled devices.
Apply Change Click it to save the settings of this page.
Interface Choose the router interface that uses RIP.
Receive
Version
Choose the interface version that receives RIP messages. You
can choose RIP1, RIP2, or Both.

Choose RIP1 indicates the router rece ives RIP v1
messages.

Choose RIP2 indicates the router rece ives RIP v2
messages.

Choose Both indicates the router re ceives RIP v1 and RIP
v2 messages.
Send Version The working mode for sending RIP messages. You can choose
RIP1 or RIP2.
45