PLANET ADE-3400 - Manual (Page 32)

Field Description
IP address is assigned by the remote DHCP server.
Local IP Address
Enter the IP address of W AN interface provided by your
ISP.
Remote IP Address Enter the gateway IP address provided by your ISP.
Netmask Enter the subnet mask of the local IP address.
Unnumbered Select this checkbox to enable IP unnumbered function.
Add
After confi guring the p arameters of this p age, click it to
add a new PVC into the Current ATM VC Table.
Modify
Select a P VC in the Current A TM VC T able, and then
modify the parameters of this PVC. After finishing, click it
to apply the settings of this PVC.
Current ATM VC Table
This table shows the existed PVCs. It shows the interface
name, channel mode, VPI/VCI, encap sulation mode,
local IP address, remote IP address and other
information. The maximum item of this table is eight.
Click it, th e PPP Interface-Modify appe ars. Y ou can
modify the PVCs’ parameters.
Click in the PPPoE mode, the page shown in the following figure appears. In this page,
you can configure parameters of this PPPoE PVC.
The following table describes the parameters and buttons of this page:
Field Description
Protocol
It displays the protocol type used for this W AN
connection.
ATM VCC
The ATM virtual circuit connection assigned for this PPP
interface (VPI/VCI).
Login Name The user name provided by your ISP.
Password The password provided by your ISP.
Authentication
Method
You can choose AUTO, CHAP, or PAP.
Connection Type You can choose Continuous, Connect on Demand, or
Manual.
Idle Time (s) If choose Connect on Demand , you need to enter the
32