PLANET ADE-3400 - Manual (Page 23)

The following table describes the parameters of this page:
Field Description
PVC Settings

VPI: Virtual Path Identifier (VPI) is the virtual p ath between
two points in an ATM network, and its valid value is from 0 to
255.

VCI: V irtual Channel Identifier (VCI) is the virtual channel
between two point s in an A TM network, ranging from 32 to
65535 (0 to 31 is reserved fo r local management of A TM
traffic).
Encapsulation
Select the method of encap sulation provided by your ISP . You
can select LLC/SNAP or VC-Mux.
Channel Mode
Select the WAN connection type. You can select 1483 Bridged,
1483 MER , PPP over Ethernet (PPPoE) , PPP over A TM
(PPPoA), or 1483 Routed . In this example, 1483 Routed is
selected.
WAN IP Settings

Obtain an IP address automatically : Obt ain the DNS
server assigned by the uplink equipment, such as BAS.

Use the follow ing IP address: Enter the st atic IP address
provided by your ISP.
Default Route You can select Enable or Disable.
DNS Settings

Obtain DNS Automatically : IP address is assigned by the
office end automatically . Y ou need not to enter the IP
address.

Use the following DNS server address: If you want to enter
the DNS server address manually , select it and enter the
related data.
After finishing the configuration, click NEXT. The p age shown in the following figure
appears.
23