PLANET ADE-3400 - Manual (Page 43)

The following table describes the parameters and buttons of this page:
Field Description
Direction Select
Select the router interface. You can select LAN or WAN.
In this example, WAN is selected.
WAN Setting You can choose Interface or IP Address.
WAN Interface
Choose the interface that permit s dat a p ackets from
WAN to access the router.
IP Address
Enter the IP address on the W AN. Only the IP address
that is in the same network segment with the IP address
on the WAN can access the router.
Services Allowed
You can choose the following services from WAN: web,
telnet, ftp, tftp, snmp, or ping. You can also choose all
the services.
Add
After setting the p arameters, click it to add an entry to
the Current ACL Table.
Reset Click it to refresh this page.
3.6 Advance
In the navi gation bar, click Advance. In th e Advance p age that is displayed cont ains
Bridge Setting, Routing, QoS, SNMP and Others.
3.6.1 Bridge Setting
Choose Advance > Bridge Setting, the page shown in the following figure appears. This
page is us ed to configure t he bridge p arameters. You can change the settings or view
some information on the bridge and its attached ports.
The following table describes the parameters and button of this page:
Field Description
Aging Time
If the host is idle for 300 sec onds (default
value), its entry is deleted from the bridge table.
802.1d Spanning Tree
You can select Disabled or Enabled.
Select Enabled to provide p ath redundancy
while prev enting undesir able loop s in y our
network.
Show MACs
Click it to show a list of the learned MAC
addresses for the bridge.
Click Show MACs, the page shown in the following figure appears. This table shows a list
of learned MAC addresses for this bridge.
43