PLANET ADE-3400 - Manual (Page 41)

The following table describes the parameters of this page:
Field Description
ACS
URL The URL of the auto-configuration server to connect to.
User Name The user name for logging in to the ACS.
Password The password for logging in to the ACS.
Periodic Inform Enable Select Enable to periodically connect to the ACS to chec k
whether the configuration updates.
Periodic Inform Interval Specify the amount of time between connections to ACS.
Connection Request
User Name The connection username provided by TR-069 service.
Password The connection password provided by TR-069 service.
Debug
Show Message
Select Enable to display ACS SOAP messages on the
serial console.
CPE sends GetRPC
Select Enable, the router cont acts the ACS to obt ain
configuration updates.
Skip MReboot
Specify whether to send an MReboot event code in the
inform message.
Delay
Specify whether to st art the TR-069 program af ter a short
delay.
Auto-Execution
Specify whether to automatically start the TR-069 after the
router is powered on.
3.5.6 ACL
Choose Service > ACL, the page shown in the following figure appears. In this page, you
can permit the data packets from LAN or WAN to access the router. You can configure the
IP address for Access Control List (ACL). If ACL is enabled, only the effective IP address
in the ACL can access the router.
Note:
If you select Enable in ACL capability, ensure that your host IP address is in ACL list
before it takes effect.
41