PLANET ADE-3100 User Manual

Page 43

HTTP Server Access: It allows you to configure where these Web pages could be
accessed from.

l

All (default): When this field is checked, it allows both WAN and LAN access to the
Web pages.

Restricted LAN: It allows the Web pages access from LAN side.

Restricted WAN Specified IP & Subnet Mask: It allows the Web access from WAN
side with a specify IP and subnet mask.

HTTP Server Port: It allows you to specify the port of the Web access. For example,
when it is changed to 8080, the HTTP server address for the LAN side is

http://10.0.0.2:8080

Range: 0 - 32767

Default: 80

FTP server: It allows you to enable or disable the FTP server connection.
System default is Enabled.

l

Disable WAN side FTP access: This will disable WAN side access to the FTP server,
default is Disabled.

TFTP server: It allows you to enable or disable the TFTP connection. System default is
Disabled.

DMZ: A DMZ (De-Militarized Zone) is added between a protected network and an
external network, in order to provide an additional layer of security. When there is a
suspected packet coming from WAN, the firewall will forward this packet to the DMZ host.

DMZ Host IP: The IP address of the DMZ host viewable at the WAN (external) side.

DHCP Dynamic Host Configuration Protocol is a communications protocol that allows
network administrators to manage and assign IP addresses to computers within the
network. DHCP provides a unique address to a computer in the network which enables it
to connect to the Internet through Internet Protocol (IP).

l

NONE: It will disable the DHCP server. Note that this setting will override the DHCP
Server Enable/Disable on the LAN configuration page.

DHCP Server (default): Select this to activate the DHCP server.

DHCP Relay: If it is enabled, the DHCP requests from local PCs will forward to the
DHCP server runs on WAN side. To have this function working properly, please
disable the NAT to run on router mode only, disable the DHCP server on the LAN
port, and make sure the routing table has the correct routing entry.

DHCP Relay Target IP: If DHCP Relay is enabled, DHCP requests are relayed to DHCP
Target IP on the WAN side.

IGMP Proxy: It is the global setting for IGMP Proxy. If it is enabled, then the enabled
IGMP Proxy on WAN PVCs will be working. Otherwise, no WAN PVC can have IGMP
Proxy working on it. System default is Disabled.

PPP Half Bridge: When PPP Half Bridge is enabled, only one PC is able to access the
Internet, and the DHCP server will duplicate the WAN IP address from the ISP to the local