PLANET ADE-3100 - Manual (Page 40)

22
configuration of RIP. The actual RIP configuration is in the RIP Per Interface
Configuration.
RIP: It allows you to Enable or Disable the RIP session. The resulting RIP session will
monitor all network interfaces that are currently available for messages from other RIP
routers. RIP is disabled by default.
Border Gateway: RIP implements Border Gateway as specified in RFC 1058 and RFC
1723. This limits all subnet routes and host routes to routers within that same network.
Updates sent outside that network will only include a single entry representing the entire
network, including all subnets and host-specific routes. The Border Gateway is enabled
by default.
Supplier Interval: It allows you to enter the Supplier Interval timer in seconds.
This timer specifies how often the RIP sends announcements as a RIP Supplier.
Range: 0 - 2147483647 Default: 30
Expire Timeout:It allows you to enter the Expire Timeout in seconds. This timer specifies
the expiration time of a route. When a route has not been updated for more than the
“expire” period of time, it is removed from the Route Table. This route is then invalidated
and remains in the internal RIP Route Table. It will be included in the RIP announcements
to let other routers know the changes.
Range: 0 - 2147483647 Default: 180
Garbage Timeout: It allows you to enter the Garbage timer in seconds. This timer
specifies how long the expired and invalidated routes are kept in the Internal RIP Route
Table before they are removed from it.