PLANET ADE-3100 - Manual (Page 13)

8
ADSL Line Status: It displays the ADSL connection process and status. The different
states for this field are as follows:
l Activation: The Router is in this state when it is attempting to start the activation
process.
l Initialization: The Router is initializing handshake with the CO.
l Training: It is a part of the handshake process with the CO.
l Channel Analysis: It is a part of the handshake process with the CO.
l Exchange: It is a part of the handshake process with the CO.
l Down: It indicates that the ADSL connection is down.
l Showtime: It indicates that a connection has been established between the
Router and the CO.
ADSL Modulation: It displays the ADSL modulation status, which can either be G.dmt or
T1.413.
ADSL Annex Mode: It displays the ADSL annex mode, which can either be Annex A or
Annex B.
ADSL Startup Attempts: It displays the number of ADSL connection attempts after loss
of showtime. A connection attempt is recorded only if showtime is attained.
ADSL Max TX Power: It displays the transmit output power level of the CPE (Customer
Premise Equipment), which is the transmit output power level of the Router.
ADSL CO Vendor: It displays the Central Office (CO) DSLAM vendor name, if available.
If the Router is not connected to an ADSL vendor, then ‘UNUSED_VENDOR_0’ will
appear in this field.
Elapsed Time: It displays the time of the Router has been in operation. This is the
amount of time the Router is on, not the amount of time it is connected to the PC or in
showtime status.
A table contained the information of SNR Margin, Line Attenuation, Errored Seconds,
Loss of Signal, Loss of Frame, CRC Errors, Data Rate, and Latency is also available.