Repeater mode – PLANET WNAP-C3220 User Manual

Page 57

User’s Manual of WNAP-C3220

- 57 -

Repeater Mode:

Repeater mode can repeat and amplify wireless signals to extend wireless network coverage. In this

mode, wireless clients are allowed to connect. When two LANs’ transmission distance is over the

wireless device’s maximum transmission value, or there is a block among the devices, you can use the

Repeater mode to deal with these problems by adding MAC addresses. The topology shows below:

WDS Repeater Mode

Step 1.

Click the Setup Wizard to configure your WNAP-C3220 as Bridge(WDS).

Step 2.

Select Bridge (WDS), and then click Next to enter the Basic Settings page.

Step 3. Select WDS AP Repeater on the drop-down box of WDS mode and the page will show

below:

Step 4. When the users select “Allow wireless client to access”, AP can also be used as “Wireless