PLANET WNAP-C3220 - Manual (Page 28)

User’s Manual of WNAP-C3220
- 28 -
WPA/WPA2-Enterprise TKIP + AES and the RADIUS server must be set.
802.1X This security mode is used when a RADIUS server is
connected to the device. 802.1x, a kind of port-based
authentication protocol, is an authentication type and
strategy for users. The port can be either a physic port or
logic port (such as VLAN). For wireless LAN users, a port
is just a channel. The final purpose of 802.11x
authentication is to check if the port can be used. If the
port is authenticated successfully, you can open this port
which allows all the messages to pass. If the port isn’t
authenticated successfully, you can keep this port
“disable” which just allows 802.1x authentication protocol
message to pass.
We strongly recommend you to enable wireless security on your network!
Only setting the same Authentication, Data Encryption and Key in the WNAP-C3220 and
other associated wireless devices can the communication be established!
Step 4. After finishing the setting, click Next to finish the Setup as shown in the figure below:
Figure 20 Setup Wizard – Finish settings of AP
Step 5. Click Save to save the configuration.