PLANET ISW-1022MPT - Manual (Page 33)

User’s Manual of ISW-1022M Series and ISW-1033MT
33
2.2.4 Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of ISW-1022M series is used for two DC redundant power input.
Please follow the steps below to insert the power wire.
1. Insert positive / negative DC power wires into the contacts 1 and 2 for POWER 2, or 5 and 6 for POWER 1.
Figure 2-12 Wiring the redundant power inputs
2. Tighten the wire-clamp screws for preventing the wires from loosing.
1 2 3 4 5 6
Power 2 Power 1
- + - +
Figure 2-13 6-Pin Terminal Block power wiring input
The wire gauge for the terminal block should be in the range between 12 ~ 24 AWG.