PLANET ISW-1022MPT - Manual (Page 32)

User’s Manual of ISW-1022M Series and ISW-1033MT
32
2. Then, lightly push the DIN-Rail into the track.
Figure 2-10 DIN-Rail mounting
3. Check if the DIN-Rail is tightened on the track or not.
4. To remove the industrial switch from the track, reverse above steps.
2.2.3 Wall Mount Plate Mounting
Follow the steps below to mount the Industrial Switch with wall mount plate.
1. Remove the DIN-Rail from the Industrial Switch; loose the screws to remove the DIN-Rail.
2. Place the wall mount plate on the rear panel of the Industrial Switch.
3. Use the screws to screw the wall mount plate on the Industrial Switch.
4. Use the hook holes at the corners of the wall mount plate to hang the Industrial Switch on the wall.
5. To remove the wall mount plate, reverse the above steps.
Figure 2-11 Wall mounting