PLANET WGSW-48000 - Manual (Page 169)

User’s Manual of WGSW-48000
169
mode. The command prompt shown at this level is:
Command Prompt: Switch#
Global Config Mode
This mode permits the operator to make modifications to the running configuration. General setup commands are grouped in
this mode. From the Global Configuration mode, the operator can enter the Interface Configuration mode. The command
prompt at this level is:
Command Prompt: Switch(Config)#
From the Global Config mode, the operator may enter the following configuration modes:
Interface Config Mode
Many features are enabled for a particular interface. The Interface commands enable or modify the operation of an interface. In
this mode, a physical port is set up for a specific logical connection operation. The command prompt at this level is:
Command Prompt: Switch(Interface )#
6.1 User Mode commands
help
Description:
This command displays help information
Syntax:
help
Mode
User Mode
logout
Description:
This command is used to exit from the telnet
Syntax:
logout
Mode
User Mode
ping
Description:
This command sends echo messages.