PLANET WGSW-48000 - Manual (Page 137)

User’s Manual of WGSW-48000
137
The page includes the following fields:
Object Description
• L2 Table Aging Enable Enable or Disable switch L2 Table aging capability.
• Aging Time Specifies the amount of time the MAC address remains in the L2 table before it is timed
out, if no traffic from the source is detected. Enter "0" means to disable aging too.
• Clear L2 Dynamic
Entries
Click on the button to clear the dynamic MAC address table.
• Entry Indicates the sequence number for valid MAC address in the L2 address table.
• Source MAC Indicates the valid MAC address in the L2 address table.
• Port Indicates the port number.
• VLAN ID Indicates the VLAN ID the valid MAC address belongs to.
• Type Indicates the MAC address type, either static or dynamic.
• Reload L2 Table Retrieves current L2 address table.
• L2 Entry Lookup To seach if MAC existed in L2 Table by entering desired MAC and its VLAN ID and then
click on "Lookup" button.
4.11.3 Static Address
A static address can be assigned to a specific interface on this switch. Static addresses are bound to the assigned interface and
cannot be moved. When a static address is seen on another interface, the address will be ignored and will not be written to the
address table (see Figure 4-11-3 )
This Static Address page provides a way to add, delete MAC addresses in the L2 address table.
Figure 4-11-3 Static Address
The page includes the following fields:
Object Description
• Add Clickes on this button to inserts a static MAC address into the L2 address table.