PLANET SGS-5220-24P2X - Manual (Page 81)

User’s Manual of SGS-5220 Series

SNMP v1 : Set SNMP trap supported version 1.

SNMP v2c : Set SNMP trap supported version 2c.

SNMP v3 : Set SNMP trap supported version 3.

Trap Community
Indicates the community access string when send SNMP trap packet. The
allowed string length is 0 to 255, and the allowed content is the ASCII characters
from 33 to 126.

Trap Destination
Address
Indicates the SNMP trap destination address.
 Trap Destination Port Indicates the SNMP trap destination port. SNMP Agent will send SNMP message
via this port, the port range is 1~65535.
 Trap Inform Mode Indicates the SNMP trap inform mode operation. Possible modes are:

Enabled : Enable SNMP trap authentication failure.

Disabled : Disable SNMP trap authentication failure.
 Trap Inform Timeout
(seconds)
Indicates the SNMP trap inform timeout.
The allowed range is 0 to 2147.
 Trap Inform Retry
Times
Indicates the SNMP trap inform retry times.
The allowed range is 0 to 255.
 Trap Probe Security
Engine ID
Indicates the SNMPv3 trap probe security engine ID mode of operation. Possible
values are:

Enabled : Enable SNMP trap probe security engine ID mode of operation.

Disabled : Disable SNMP trap probe security engine ID mode of operation.
 Trap Security Engine
ID
Indicates the SNMP trap security engine ID. SNMPv3 sends traps and informs
using USM for authentication and privacy. A unique engine ID for these traps and
informs is needed. When "Trap Probe Security Engine ID" is enabled, the ID will
be probed automatically. Otherwise, the ID specified in this field is used. The
string must contain an even number(in hexadecimal format) with number of digits
between 10 and 64, but all-zeros and all-'F's are not allowed.
 Trap Security Name Indicates the SNMP trap security name. SNMPv3 traps and informs using USM
for authentication and privacy. A unique security name is needed when traps and
informs are enabled.
 System Enable/disable that the Interface group's traps. Possible traps are:

Warm Start : Enable/disable Warm Start trap.

Cold Start : Enable/disable Cold Start trap.
 Interface Indicates that the Interface group's traps. Possible traps are:

Link Up : Enable/disable Link up trap.

Link Down : Enable/disable Link down trap.

LLDP : Enable/disable LLDP trap.
 AAA Indicates that the AAA group's traps. Possible traps are:
Authentication Fail : Enable/disable SNMP trap authentication failure trap.
81