Avago Technologies MegaRAID SATA 300-4XLP - Manual (Page 6)

vi Preface
Version 1.4 Copyright © 2004–2006 by LSI Logic Corporation. All rights reserved.
•
Engineers and managers who are evaluating the SATA 300 PCI-X or
PCI Express storage adapter storage for possible use in a system
Organization
Use this manual to install and configure your SATA 300 storage adapter
in the host system. The information in this document is independent of
the back-end bus that the system uses, and applies to both MegaRAID
SCSI storage adapters and Serial ATA storage adapters.
This document has the following chapters and appendixes:
•
Chapter 1, Introduction , describes the SATA 300 PCI-X and PCI
Express storage adapters.
•
Chapter 2, Hardware Installation , describes how to install a
SATA 300 PCI-X or PCI Express storage adapter in a system.
•
Chapter 3, SATA 300 Storage Adapter Specifications , provides the
environmental and electrical specifications for the SATA 300 PCI-X
and PCI Express storage adapters. This chapter also provides the
board graphic, jumper definitions, and connector locations for the
SATA 300 storage adapters.
•
Appendix A, Glossary of Terms , lists and explains terms and
abbreviations that are used in this manual.
•
Appendix B, MegaRAID Problem Report Form , provides forms to
send or fax to LSI Logic if you encounter difficulty with a SATA 300
PCI-X or PCI Express storage adapter.
Related Publications
MegaRAID Device Driver Installation User’s Guide
Document Number: DB11-000018-02
This document explains how to install the MegaRAID device driver for
your operating system. The information in this document is independent
of the back-end bus and applies to both MegaRAID SCSI storage
adapters and Serial ATA storage adapters.
MegaRAID Configuration Software User’s Guide
Document Number: DB15-000269-01