Avago Technologies MegaRAID SATA 300-4XLP - Manual (Page 29)

Post-Installation Steps 2-5
Version 1.4 Copyright © 2004–2006 by LSI Logic Corporation. All rights reserved.
“SATA 300 Storage Adapter Specifications,” shows the
connector locations on the SATA 300 storage adapters.
Step 8. Replace the computer cover and power-up the system.
Replace the computer cover and reconnect the power cords.
Power-up the computer.
During boot, the MegaRAID BIOS message appears:
MegaRAID BIOS Version x.xx date
(c) Copyright 2005, LSI Logic Corporation, USA
MegaRAID SATA Adapter Card found at PCI Bus No:xx
Dev No:xx
The firmware takes several seconds to initialize. During this
time the adapter scans the Serial ATA ports.
2.4 Post-Installation Steps
After you install the storage adapter, you must install the device driver
and define the logical drives and physical disk arrays. Refer to the
MegaRAID Device Driver Installation User’s Guide for detailed device
driver installation steps. Refer to the MegaRAID Configuration Software
User’s Guide for detailed steps on configuring physical arrays and logical
drives.