2 features, Features – Avago Technologies MegaRAID SATA 300-4XLP User Manual
Page 21

Features
1-5
Version 1.4
Copyright © 2004–2006 by LSI Logic Corporation. All rights reserved.
1.2
Features
This section highlights the features of the SATA 300 storage adapters.
The SATA 300 adapters are intelligent storage adapters that do the
following:
•
Provide four or eight internal SATA ports
•
Support the Serial ATA 1.0 and Serial ATA II: Extensions to Serial
ATA 1.0 specifications:
–
Provide a 150 Mbytes/s and 300 Mbytes/s data transfer rate
–
Use a low-cost, small 7-pin connector with thin, flexible cables
(SATA 300-8X)
–
Use a 26-circuit, high-speed iPASS connector (SATA 300-4XLP
and SATA 300-8XLP)
–
Use a 36-circuit, high-speed iPASS connector (SATA 300-4ELP
and SATA 300-8ELP)
–
Use low-voltage signaling levels to reduce current draw,
electromagnetic emission, and signal switching time
–
Support enclosure management, using an I
2
C interface to
communicate with an SEP
•
Support the PCI-X Specification, Revision 1.0a: (SATA 300-4XLP,
SATA 300-8X, and SATA 300-8XLP)
–
Provide up to 64-bit, 133-MHz data transfers from the host
system to the SATA 300 controller
–
Provide backward compatibility with previous implementations of
the PCI specification
–
Conform to the half-size PCI form factor (SATA 300-8X)
–
Conform to the low-profile PCI with extended length form factor
(SATA 300-4XLP and SATA 300-8XLP)
•
Comply with the PCI Express Specification, Revision 1.0a: (SATA
300-4ELP and SATA 300-8ELP)
–
Provide PCI Express x 4 lane configuration
–
Support transfers rates of up to 2.5 Gbits/s per PCI Express lane
–
Support a dedicated PCI Express bus