Avago Technologies MegaRAID SATA 300-4XLP - Manual (Page 28)

2-4 Hardware Installation
Version 1.4 Copyright © 2004–2006 by LSI Logic Corporation. All rights reserved.
Align the SATA 300 PCI Express storage adapter to a PCI
Express slot. Press down gently (but firmly) to properly seat the
storage adapter in the slot.
Figure 2.2 shows how to insert the
SATA 300 PCI Express storage adapter into a slot.
Figure 2.2 Inserting a MegaRAID SATA 300 Storage Adapter into a
PCI Express Slot
Step 5. Screw the bracket to the computer frame.
Step 6. Configure the Serial ATA devices and install them in the host
system computer case.
Refer to the documentation for the Serial ATA device for any
pre-installation configuration requirements.
Step 7. Connect the Serial ATA cables between the SATA 300 storage
adapter and the Serial ATA devices.
Chapter 3,
32-bit Slots
64-bit Slots
(3.3 V)
(3.3 V)
Edge of
Main Board
Bracket Screw
Press Here
Press Here