Avago Technologies MegaRAID SATA 300-4XLP - Manual (Page 44)

3-14 SATA 300 Storage Adapter Specifications
Version 1.4 Copyright © 2004–2006 by LSI Logic Corporation. All rights reserved.
3.3 Physical and Environmental Specifications
The design and implementation of the Serial ATA storage adapters
minimize electromagnetic emissions, susceptibility to radio frequency
energy, and the effects of electrostatic discharge. The board carries the
CE mark, C-Tick mark, FCC Self-Certification logo, Canadian
Compliance Statement, Korean MIC, Taiwan BSMI, Japan VCCI. In
addition, the board meets the requirements of CISPR Class B.
MegaRAID SATA 300-4XLP (Model 01039), and MegaRAID SATA 300-
4ELP (Model 01091), MegaRAID SATA 300-8X (Model 01038),
MegaRAID SATA 300-8XLP (Model 01039), and MegaRAID SATA 300-
8ELP (Model 01091) storage adapters are CSA C22.2 No. 60950-1, UL
60950-1 First Edition listed Accessory, UL file number E257743.
3.3.1 Safety Characteristics
All SATA storage adapters meet or exceed the UL flammability rating 94
V0 requirements. Each bare board is marked with the supplier name or
trademark, type, and UL flammability rating. Because these boards are
installed in a PCI-X bus slot, all voltages are lower than the SELV 42.4 V
limit.
J8 LED Drive
Fault Connector Interface 16-pin (8x2) jumper.
Provides LED interface individually to eight SATA II ports.
The LED indicates a drive fault on particular ports.
J9, J10 SATA 300-8ELP Ports Ports 0–7.
These ports connect the cables from the adapter to the SATA
physical drives.
J11 Battery Backup Connector
(located on the back side of
the RAID controller) 20-pin connector.
Provides interface to the remote battery pack.
Table 3.6 SATA 300-8ELP Connectors and Jumpers (Cont.)
Jumper Type Description