Epson Professional Series II - Manual (Page 40)

If you press FUNCT when the LCD displays
5. To exit from this display, press
3. Using a horizontal green line as your reference, adjust the
red and blue beams until the line is sharp, distinct, and
completely white. To do this, press and hold down the
or side of the Adjustment button to separate the red and
blue beams or move them closer together, as shown in the
table below. (The green beams remain in place.) A scale
of 0 to 9 is available and the factory setting is 4.
Adjusting the vertical convergence
Adjustment button Red beams move Blue beams move
+
D o w n
r e d
b l u e
g r e e n
horizontal lines
4. To adjust the horizontal convergence, press FUNCT until
the LCD displays Horiz Conv.
32 Professional Series II Monitor