Epson Professional Series II - Manual (Page 37)

3.
4.
5
Pressing FUNCT accesses the display parameters in the order
listed in the table below. You can press MEM RCL to move
backward through the parameters.
Display parameter order
Parameter LCD message
Horizontal phase H o r P h a s e
W i d t h W i d t h
Vertical shift V e r t S h i f t
H e i g h t
V e r t i c a l c o n v e r g e n c e
l
V e r t
H o r i z o n t a l c o n v e r g e n c e
l
C o l o r t e m p e r a t u r e
l
C o l o r T e m p
Changes you make to these parameters apply to all video modes
Sections later in this manual describe how to set them
Note
If you press FUNCT when the LCD displays
Color Temp: 3, the LCD displays a message such as
R E D a d j u s t : 5. To exit from this display, press
MEM SEL twice.
Adjust the image using the Adjustment button as described
in the table on pages 23 and 24.
Press FUNCT until you see the name of the next parameter
(if any) you want to change and then adjust the image.
Repeat steps 3 and 4 until you are satisfied with the image
you see.