Epson Professional Series II - Manual (Page 23)

To maximize the brightness of all the monitors you connect,
always set the switches to HIGH on all the monitors
except the last one and set the last monitor’s switch to 75R.
For example, if you connect three monitors to one video
controller, set the switches on the monitors as shown below.
If one of the monitors you are connecting does not have a
switch, it is probably permanently set to 7512; use
it only as the last monitor (monitor 3 below).
c o m p u t e r monitor 1 monitor 2 monitor 3
9. Plug each monitor’s power cord into the AC power inlet on
its back panel and then into a grounded (earthed) electrical
outlet.
Connecting three monitors
To connect three monitors to one video interface, follow the
appropriate steps above as well as these general guidelines:
Connect T connectors to the BNC connectors on the first
and second monitors.
Connect the color-coded video interface cable to the
computer’s video interface and the appropriate
T connectors on the first monitor.
Use video interface cables to connect the first monitor
to the second monitor and the second monitor to the third
monitor.
Set the monitors’ switches as described at the top
of this page.
Professional Series II Monitor 15