Pop3 security – TA Triumph-Adler P-3020 MFP User Manual
Page 368

8-162
Default Setting (System Menu)
POP3 Security
Select the communication protocol according to the type of security employed by the POP3 server. The default setting
is Off.
NOTE:
POP3 (E-mail RX) must be set to On in Protocol Detail on page 8-151.
The table below shows the available settings.
* You can change the port number using Embedded Web Server RX.
Use the procedure below to make the setting.
1
In the Sys. Menu/Count. menu, press the or key to
select [System/Network], and press the OK key.
A login screen will appear. Then, enter the user ID and
password with administrator privileges to log in, and
press [Login] (the Right Select key).
2
The System/Network menu appears.
3
Press the or key to select [Network Setting].
4
Press the OK key. The Network Setting menu appears.
Item
Description
Off
Do not use security employed by the POP3 server.
SSL/TLS
Encryption is applied any data communication. To enable POP3 security, the
POP3 port may have to be changed according to the server settings.
Typically, 995* for SSL/TLS is well-known POP3 port.
STARTTLS
Encryption is applied any data communication. Typically, 110* for STARTTLS
is well-known POP3 port.
Sys. Menu/Count.:a b
1 Report
2 Counter
*********************
[ Exit
]
3 System/Network
Login User Name: L
b
*******************
Login Password:
[ Login
]
System/Network:
a b
*********************
2 I/F Block Set.
3 Security Level
[ Exit
]
1 Network Setting
Network Setting: a b
*********************
6 Host Name
7 LAN Interface
[ Exit
]
5 Secure Protocol