TA Triumph-Adler DC 2020 - Manual (Page 46)

CHAPTER 6 COPIER MANAGEMENT
Copy default setting
! BORDER WIDTH
@ DEFAULT
DRAWER
# OUTPUT FORM
$ ROTATE SORT
Content of copy default setting
Sets the initial value of the border erase width for the sheet erase or
book erase in the border erase mode (page 5-6).
Specifies the paper feed drawer to be selected automatically when
warm-up ends or when the Clear All key is pressed. Paper feed drawer
3 and 4 can be selected only when the optional drawer is installed.
Sets whether or not to perform sort copying (page 5-9).
Sets whether the normal sort copy (page 5-9) or rotate sort copy (page
5-9) is used when the sort mode is selected.
• This setting is not displayed when the copier is equipped with the
optional finisher.
Setting range
6, 12, 18 mm
SOURCE 1 to
SOURCE 4
SORT: ON/
SORT: OFF
ON/OFF
Default setting
6 mm
SOURCE 1
SORT: OFF
OFF
Page
6-13
6-13
6-13
6-13
6-10