TA Triumph-Adler DC 2020 - Manual (Page 11)

CHAPTER 2 NAMES OF PARTS
2-2
1 Original cover
(Open/close to set the original on the platen.)
2 Operation panel
(Contains the keys and indicators for operating the copier.)
3 Left cover handle
(Hold to open the left cover.)
4 Left cover
(Open when a paper misfeed occurs.)
5 Multi-Bypass
(Load paper here when copying onto small-size or special
paper.)
6 Insert guides
(Be sure to set the paper width when loading paper on the
multi-bypass.)
7 Support tray
(Operate to use large-size paper.)
8 Toner cartridge
9 Toner cartridge release lever
(Operate to replace the toner cartridge.)
0 Waste toner tank
! Waste toner tank release lever
(Operate to replace the waste toner tank.)
@ Cleaning shaft
(Pull and push back in after toner cartridge replacement or
when copy images become soiled with toner.)
# Front cover
(Open to replace the toner cartridge or waste toner tank.)
$ Main switch
(Turn ON (|) before starting to make copies.)
% Copy store section
(Copied paper is stored here.)
^ Ejection section
& Platen
(Set originals here for copying. Place originals face-down
with the edges aligned with the size scales on the left and
rear sides of the platen.)
* Original size scales
(Be sure to align the original with these when setting the
original on the platen.)
( Drawer 1
(Holds up to 250 sheets of standard paper [standard paper
specified by our company].)
) Drawer 2
(Holds up to 250 sheets of standard paper [standard paper
specified by our company].)
⁄ Drawer left cover
(Open when a paper misfeed occurs inside the drawer left
cover.)
¤ Length adjustment plate
(Adjust to the length of the paper to be set in the drawer.)
‹ Width adjustment lever
(Hold the lever and adjust the width guide to the width of
the paper to be set in the drawer.)
› Drawer bottom plate
(Push down when loading paper.)
fi Handles for transport
(The right two handles are indented handles. The left two
become handles when pulled out.)