TA Triumph-Adler CLP 4416 - Manual (Page 49)

Setting your machine
3-9
Op
erat
ion
Setting your
machine
Getting started
Directory
Maintenance
Safet
y
Contents
Instal
lat
ion
To set the technical parameters:
29 OK - SETUP / TECHNICALS
+ Select the desired parameter and confirm with OK.
+
With the or keys, modify the parameter settings by following the table below and
press OK.
Parameter Setting Signification
1 - SCANNING
MODE 1 - NORMAL
2 - FINE
3 - SFINE
4 - PHOTO Default value of the scan mode resolution for the documents
to be transmitted.
2 - TX HEADER 1 - WITH
2 - WITHOUT If this parameter is on, your header will appear on all
documents sent to your subscribers with your name, number,
date and number of pages.
Warning: If you send a fax from the document loader, the
transmission header will not appear on the document your
correspondent receives.
3 - TX SPEED 1 - 33600
2 - 14400
3 - 12000
4 - 9600
5 - 7200
6 - 4800
7 - 2400 Transmission speed for outgoing documents.
For a quality telephone line (compatible, no echo),
communications occur at maximum speed.
However, it may be necessary to restrict the transmission
speed for some calls.
4 - ECHO PROTECT 1 - WITH
2 - WITHOUT If this parameter is on, the on-line echo will be reduced during
long distance calls.
6 - EPT MODE 1 - WITH
2 - WITHOUT For some long distance calls (satellite), the on-line echo may
disturb the call.
7 - COM. DISPLAY 1 - SPEED
2 - PAGE NUMBER Choice between transmission speed displayed or number of
the page in progress.
8 - ECO ENERGY 1 - WITHOUT
2 - DELAY
5 MIN
3 - DELAY
15 MIN
4 - DELAY
30 MIN
5 - DELAY
60 MIN Choosing the printer standby delay: the printer will switch to
standby after a delay (in minutes) of NON-operation or during
the period of time of your choice.
10 - RX HEADER 1 - WITH
2 - WITHOUT If this parameter is on, all documents received by your fax
will include the subscriber’s header with his name, number (if
available) fax print date and the page number.