TA Triumph-Adler CLP 4416 - Manual (Page 141)

Maintenance
6-25
Op
erat
ion
Se
tti
ng your
mac
h
in
e
Getting started
Directory
Maintenance
Safet
y
Contents
Instal
lat
ion
Faint or blurred
printing Clean the main charger units.
Open the left cover. Slowly pull the green wire cleaner knob to each of
the main charger units in and out a few times. For full details, see
Cleaning the Main Charger Unit on p. 6-10.
Clean the advanced beam array lenses.
Open the left cover. Slowly pull the green lens cleaner knob in and out 2
times. For full details, see Cleaning the Advanced Beam Array Lenses on
p. 6-12.
Make sure the paper type setting is correct the paper being used.
See the Using the Operator Panel section in the Advanced Operation
Guide.
Conduct color calibration either by switching the printer off then on or
using the printer operator panel. For full details, see the Using the
Operator Panel section in the Advanced Operation Guide.
Try adjusting the color control settings using the printer driver.
Check the operator panel. If the Toner low (C/M/Y/K) message is
displayed with color description, install a new toner kit for the color. To
replace toner, see Toner Container Replacement on p. 6-3.
Refresh drum.
Perform the following procedures on the operator panel and try cleaning
the drum surface using the printer's built-in cleaning system.
+ Press [MENU].
+ Press or repeatedly until >Others appears.
+ Press . Press or repeatedly until e >Service appears.
+ Press . Press or repeatedly until >>Drum appears.
+ Press [ENTER] twice.
+
The message display shows Please wait. After approx. 3
minutes, the display returns to Ready.
Printed Results Corrective Action