TA Triumph-Adler CLP 4416 - Manual (Page 101)

Operation
5-21
Op
erat
ion
Se
tti
ng your
mac
h
in
e
Getting started
Directory
Maintenance
Safet
y
Contents
Instal
lat
ion
Compatible USB keys
The memory keys must be FAT16 or FAT32 formatted for the terminal to be able to read them.
NTFS formatted memory keys are not compatible with the terminal.
Informations on the use of the photo memory device
• Take due care when inserting the memory device in the appropriate slot and make sure it is
inserted with the correct orientation.
• Do not use more that one device at the same time!
• If your multifunction terminal cannot read the memory device that you are using, check that
it is compatible and that you have inserted it correctly.
• Once in place, do not remove the device before the multifunction terminal has finished all
the print commands.
• If the "MEDIA ERROR - WRITE ERROR" message is displayed during a recording or era-
sing operation on a memory support, this means that the latter is write-protected. Recording
or erasing is possible only after this protection has been de-activated.
• A write-protected file (read-only) cannot be deleted from a memory support.
Note: The Analyse Media function allows you at all times to consult the contents of the inserted memory card,
and this even if you have quit the media menu and the terminal is again in initial mode. Press /OK
and 08.
P
RINTING A PHOTO FROM A MEMORY DEVICE
Your multifunction terminal is equipped with all the tools and connections needed to make it into
a fully independent photo printer. You can print your digital photos from a photo memory card
or from a USB memory key.
Supported image files
You can use photo files that meet the following requirements:
Device format Compatible DCF (Design Rule for Camera File System (Version
1.0))
File format JPG (JPEG) BASELINE Format
Image size Maximum 6 Mb
Supported resolution between 76800 and 12 million pixels
N° of files recognised Up to 999