RIGOL DSG3000 Series - Manual (Page 88)

RIGOL Chapter 2 Front Panel Operations
2-48 DSG3000 User’s Guide
Beeper
Press Beeper to select “On” or “Off”.
Recorder
In recording file, the measurement data is saved as a record csv file according to the
current parameter settings.
Start
Press Start to start recording the power meter measurement data. The message
“Power meter starts recording” is displayed in the user interface.
Stop
Press Stop to stop recording the measurement data. At this point, the message
“Power meter stops recording, please save the data” is displayed in the user interface
and the instrument enters the store and recall interface. Then, press Enter or the
right direction key to unfold the current directory and press Save to store this file.
For more information about storing the file, please refer to “ Save”.
Count
Press Count to set the maximum length of the data that can be currently recorded.
The range is from 0 to 65535.
Sample Rate
Press Sample to set the clock rate of the data points recording.
Data Content
Set the data content to be recorded.
Press content to select “All” or “Limit”.
 All: record all of the measurement data.
 Limit: only record the limit values of the measurement data.