RIGOL DSG3000 Series - Manual (Page 123)

Chapter 4 Application Examples RIGOL
DSG3000 User’s Guide 4-7
 Run
Press Run, you can set the current pulse value to the internal modulating
signal.
4. Select the Pulse Mode
Press Pulse  Source to select “Int” modulation source; press Mode to select
“Train”.
5. Enable the Pulse Output
Press Pulse Out, and select “On” to enable the pulse output function. At this
point, the RF signal generator can output the pulse signal generated by internal
pulse train generator from the [PULSE IN/OUT] connector at the rear panel.