RIGOL DSG3000 Series - Manual (Page 50)

RIGOL Chapter 2 Front Panel Operations
2-10 DSG3000 User’s Guide
Sweep
When the sweep function is enabled, the RF signal generator outputs RF sweep
signal from the [RF OUTPUT 50Ω] connector (as shown in the figure below) at the
front panel (at this point, RF output switch is turned on).
Sweep Manner
DSG3000 provides three sweep manners (“Freq”, “Level” and “Freq & Lev”). The
sweep function is enabled when any of the sweep manners is selected and the Swp
label will be displayed in the function status area in the user interface. By default, the
sweep function is turned off.
Press SWEEP  Sweep to select the desired manner.
 Off: the default state. Turn off the sweep function.
 Freq: enable the frequency sweep function. At this point, the frequency sweep
progress bar is displayed in the frequency area in the user interface.
 Level: enable the amplitude sweep function. At this point, the amplitude sweep
progress bar is displayed in the amplitude area in the user interface.
 Freq & Lev: enable the frequency and amplitude sweep functions at the same
time. At this point, the frequency and amplitude sweep progress bars are
displayed in the frequency and amplitude areas in the user interface
respectively.
Sweep Direction
Press SWEEP and use the page up/down key
to open the 3/3 menu page;
then, press Direct to select “Fwd” or “Down” and the default is “Fwd”.
 Fwd: the RF signal generator sweeps from the start frequency or start level to
the stop frequency or stop level. The progress bar in the frequency area and
amplitude area in the user interface sweeps from left to right.
 Down: the RF signal generator sweeps from the stop frequency or stop level to
the start frequency or start level. The progress bar in the frequency area and
amplitude area in the user interface sweeps from right to left.