RIGOL DSG3000 Series - Manual (Page 111)

Chapter 3 Remote Control RIGOL
DSG3000 User’s Guide 3-5
Control Via LAN
1. Connect the devices
Connect the RF signal generator to your LAN using network cable.
2. Configure LAN parameters
Set the LAN parameters of the RF signal generator according to the description
in “I/O Config  LAN”.
3. Search device resource
Start-up Ultra Sigma and click , then click in the
pop-up window, the software starts seaching the RF signal generator resources
connected to LAN. Instrument resources seached will be displayed in the right of
the window. Select your desired resource and click
, as shown in the
following figures.
(a)
(b)
Figure 3-3 Search LAN resource
NOTE: The resource selected should keep consistency with IP address of the
DSG3000 LAN interface.