RIGOL DSG3000 Series - Manual (Page 80)

RIGOL Chapter 2 Front Panel Operations
2-40 DSG3000 User’s Guide
To Select the LF Waveform
Press  LF  Waveform to set the waveform of the LF output signal to
“Sine”, “Square”, “Triangle”, “Ramp” or “Swp-Sine” and the default is “Sine”.
To Set the LF Amplitude
Press  LF  Level to set the amplitude of the LF signal.
 Use the numeric keyboard to input the amplitude value and select the desired
unit from the pop-up unit menu or unit keys. You can also press Enter to select
the default unit (V).
 The amplitude units available are V, mV, μV, nV and dBm.
 You can press the left/right direction keys to enter the parameter editing state
and move the cursor to the specified digit and use the up/down direction keys or
knob to modify the parameter value.
 You can also use the up/down direction keys or knob to modify the amplitude at
the current step.
 Press Step to set the step.
 The ranges of Sine, Square, Triangle and Ramp waveform amplitude are from
1mV to 3V.
To Set the LF Frequency
Press  LF  Freq to set the frequency of the LF signal.
 Use the numeric keyboard to input the frequency value and select the desired
unit from the pop-up unit menu or unit keys. You can also press Enter to select
the default unit (Hz).
 The frequency units available are GHz, MHz, kHz and Hz.
 You can press the left/right direction keys to enter the parameter editing state
and move the cursor to the specified digit and use the up/down direction keys or
knob to modify the parameter value.
 After setting the frequency, you can use the up/down direction keys or knob to
modify the frequency at the current step.
 Press Step to set the step.