RIGOL DSG3000 Series - Manual (Page 76)

RIGOL
26 DSG3000 Quick Guide
Remote Control
DSG3000 supports to build communication with the PC via USB, LAN or GPIB
interface to realize remote control. The remote control is realized on the basis of the
SCPI command set (Standard Commands for Programmable Instruments). This
section introduces how to send SCPI commands through the RIGOL common PC
software Ultra Sigma to control the RF signal generator remotely via the USB
interface. For the detailed information of the commands, refer to DSG3000
Programming Guide .
Note: When the instrument is in remote mode,
is displayed in the user
interface and all the front panel keys (except Esc) are locked. At this point, you can
press Esc to exit the remote mode.
1. Install Ultra Sigma
Acquire the Ultra Sigma software and install it as well as its components
according to the instructions. This software is contained in the resource CD in
the standard accessories. You can also download the latest version of the
software from www.rigol.com .
2. Control via USB
(1) Connect the device
Connect the RF signal generator (USB Device) and PC (USB Host) using a
USB cable.
(2) Install USB drive
This RF signal generator is USBTMC device and the Found New
Hardware Wizard will be displayed after the RF signal generator is
correctly connected to the PC (the signal generator will be automatically
configured to USB interface) and both of them are started. Please install the
“USB Test and Measurement Device” drive program according to the
instructions.
(3) Search for device resource
Start Ultra Sigma and the software will search for the RF signal generator
resource currently connected to the PC automatically. You can also click
to search for the resource manually.