RIGOL DSG3000 Series User Manual

Page 67

RIGOL

DSG3000 Quick Guide

2. Status Bar

Indicate the states of some of the RF signal generator functions.
—

: Displayed when the LF output is enabled.

—

: Displayed when the RF modulation output is enabled.

—

: Displayed when the RF output is enabled.

—

: The RF signal generator is working in remote control mode.

—

: The RF signal generator is working in local mode.

3. Amplitude Area

Display the current level setting of the RF signal generator.
—

: Displayed when the attenuation mode is “Fixed”.

—

: Displayed when the ALC state is “On”.

—

: Displayed when the ALC state is “Auto”.

—

: Displayed when the flatness calibration switch is “On”.

—

: Displayed when the amplitude offset is not 0 dB.

—

: Continuous sweep label. Displayed when the sweep type is “Level” or

“Freq&Lev” and the sweep mode is “Cont”.

—

: Single sweep label. Displayed when the sweep type is “Level” or

“Freq&Lev” and the sweep mode is “Single”.

—

: Forward sweep label. Displayed when the sweep type is “Level” or

“Freq&Lev” and the sweep direction is “Fwd”.

—

: Down sweep label. Displayed when the sweep type is “Level” or

“Freq&Lev” and the sweep direction is “Down”.

—

: Amplitude sweep progress bar. Displayed when the

sweep type is “Level” or “Freq&Lev”.

4. Menu Display Area

This area defines the annotations of the menu softkeys at the right of the screen.

The annotations of the menu softkeys change according to the function selected.

Pressing any softkey can enable the corresponding function.

5. Error Message Display Area

Display the message in abbreviated form. When multiple messages are

generated, only the latest message will be displayed. To view the messages

recently displayed, press System  Information  System Msg.

6. Function Status Area

Display the current active states of each function. Each function corresponds to

at most four kinds of states as shown in the table below.