RIGOL DSG3000 Series - Manual (Page 73)

RIGOL
DSG3000 Quick Guide 23
 Stop Frequency
Press Stop Freq, use the numeric keyboard to input the stop frequency
value (2) and select the desired unit (GHz) from the pop-up unit menu or
unit keys.
 Start Level
Press Start Lev, use the numeric keyboard to input the start level value
(-20) and select the desired unit (dBm) from the pop-up unit menu or unit
keys. You can also press Enter to select the default unit (dBm).
 Stop Level
Press Stop Lev, use the numeric keyboard to input the stop level value (0)
and select the desired unit (dBm) from the pop-up unit menu or unit keys.
You can also press Enter to select the default unit (dBm).
 Sweep Points
Press Points, use the numeric keyboard to input the number of sweep
points (10) and then press OK or Enter.
 Dwell Time
The dwell time indicates the duration of a sweep step.
Press Dwell Time, use the numeric keyboard to input the time value (500)
and select the desired unit (ms) from the pop-up unit menu or unit keys.
3. Enable the RF sweep
Press SWEEP  Sweep and select “Freq&Level” to enable the frequency and
amplitude sweep functions at the same time.
At this point, the RF signal generator sweeps from the start frequency and level
to the stop frequency and level continuously at certain step according to the
current settings. The frequency and amplitude sweep progress bars as well as
the continuous sweep label are displayed in the frequency and amplitude areas
in the user interface respectively.
4. Enable the RF output
Press RF, the backlight goes on and the RF label is displayed in the status bar of
the user interface. The RF output is enabled. At this point, the [RF OUTPUT
50Ω] connector outputs RF sweep signal according to the current configuration.