RIGOL DSG3000 Series - Manual (Page 66)

RIGOL
16 DSG3000 Quick Guide
User Interface
The user interface of DSG3000 series RF signal generator provides two display
modes: normal display mode and parameter zoom-in mode. At power-on, the
instrument enters the normal display mode by default. In this manual, the normal
display mode of DSG3060 is taken as an example to illustrate the user interface of
the instrument.
Normal Display Mode
1 2 3 4
5 6 7
Figure 5 User Interface (Normal Display Mode)
1. Frequency Area
Display the current frequency setting of the RF signal generator.
—
: Displayed when the frequency offset is not 0 Hz.
— : Continuous sweep label. Displayed when the sweep type is “Freq” or
“Freq&Lev” and the sweep mode is “Cont”.
— : Single sweep label. Displayed when the sweep type is “Freq” or
“Freq&Lev” and the sweep mode is “Single”.
— : Forward sweep label. Displayed when the sweep type is “Freq” or
“Freq&Lev” and the sweep direction is “Fwd”.
—
: Down sweep label. Displayed when the sweep type is “Freq” or
“Freq&Lev” and the sweep direction is “Down”.
— : Frequency sweep progress bar. Displayed when the
sweep type is “Freq” or “Freq&Lev”.