MINOURA HPS-9 “Get’A” - Manual (Page 2)

How To Remove Tire Lever
To remove the tire lever, simply turn upward then
pull out.
To store, insert the projection on the lever tail
down.
!
Do not force to push down the lever.
Additional Cautions
●When using phillips screwdriver, straighten the tool,
pushing toward the screw.
●The pivot bolt may loosen with use. Tighten as
needed with an M4 hex wrench.
or closing the tool.
●The tire levers can only be stored one way.
●Make sure your bike is stable before letting go after
set up.
or similar may be used under the leg for stability.
●Do not mount or apply a load to bike when it's in
the stand.
Remove any luggage or excess weight before
using stand.
sizes and bike types.
●If tool becomes wet, wipe dry immediately. Do not
put into tool box wet or rust may occur.
●Minoura assumes no responsibility or lability for
damage to your bike or person from misuse of this
stand.
Warranty Period :
1 year from your purchase