MINOURA FCG-310 - Manual (Page 2)

6. Flip over the wheel and attach the FCG-310 onto
the opposite side of the wheel.
Do not change the Gauge Plate position yet.
At this time, if all three points (both Rim Guides
and the tip of the Gauge Plate) touch each
appropriate postion at once on both side of
the wheel (see Fig. B), your wheel is properly
assembled and adjusted.
But if either one of the Rim Guides or the Gauge
Plate doesn't touch the appropriate position (see
Fig. C), your wheel needs to be adjusted further.
If the Rim Guide doesn't touch the rim, the wheel
has been moved toward opposite side.
If the Gauge Plate doesn't touch the hub even
though both Rim Guides touch the rim, your wheel
has been moved backward.
Set the wheel on the wheel truing stand to adjust. To know how to adjust the wheel, refer the instructions
manual of the wheel truing stand.
(Fig. B)
(Fig. C)
Properly Adjusted
Wrong Adjsuted
!
It is crucial to measure the wheel at several different points to get proper result.
Useful Additional Features
FCG-310 can be used on most wheels sized between 24" and 29"/700c in the standard position.
In addition, you can use it for the smaller wheel (18" or larger) and the wide (up to 140mm) hub wheel which is used on
some DH, FR and city commuting bikes by changing the the Rim Guide position. (see Fig. D & E)
Make both Rim Guides inward Step down both Rim Guides
How To Fold Down FCG-310
(Fig. D)
(Fig. E)
(Fig. F)
1) Loosen the Knob Bolt fully.
2) Separate the Ratches as if pulling outward on each other.
3) Rotate the Gauge Plate as the hole faces outward.
4) Fold the Frame.
!
Do not tighten the Knob Bolt while the hole of the Gauge Plate
is facing inward, otherwise the Gauge Plate will be bent.
Please be sure the Gauge Plate cannot be replaced.
MINOURA JAPAN (for ALL customers) MINOURA NORTH AMERICA (for U.S. residents only)
1197-1 Godo, Anpachi, Gifu 503-2305 Japan Hayward, California, U.S.A.
Phone +81-584-27-3131 / Fax +81-584-27-7505 Phone 1-510-538-8599 / Fax 1-510-538-5899
[email protected] / www.minoura.jp [email protected]
The hole must be outward
Made in Japan
Contact