MINOURA HMS-10 - Manual (Page 2)

Assembling HMS-10
Required Tool : 17mm spanner
Remove Velcro tape and fully open both d left side legs. (Fig. A
& B)
Be sure the legs must be pulled (the pivot bolt in the long hole is
located near side) when opening.
(Fig. B & C)
Open the lever of the quick release skewer on the leg to open the
clearance at the bottom nut, then push the leg toward the pillar
until the pivot bolt reaches the hole end. (Fig. D)
Close the skewer lever beyond the leg bracket to be locked
securely. (Fig. E)
(Fig. C)
M10 Flat Washer
10mm Nylon Nut
Install the saddle holder and washers to the pillar top.
Tighten the Nylon nut with a 17mm spanner. (Fig. F)
You don't have to fix the saddle holder, it must be able to
rotate slowly when applying bike weight.
But be sure that free rotation could be dangerous because
the bike will not be supported stable.
The bike will be positioned automatically due to the
weight balance that the front tire touches the floor. It is
the standard working position.
The tube pad of the saddle holder must wear.
Replace it when it's damaged. Using with broken pad
should scratch the saddle rail or seat post.
Saddle Holder
! Please be advised that it's dangerous
the bike is suported while both front
and rear tires are off from the floor.
It should spoil the weight balance and
fall down easily.
(Fig. D)
(Fig. E)
(Fig. B)
(Fig. A)
(Fig. F)
Leg
Pillar
Quik Release Skewer
Velcro Tape
If the skewer is not securely tightened,
open the lever and turn the nut to
adjust the lever tightness correctly.