MINOURA W-3100 User Manual
Page 2
2
Place the assembled Lower Frame on the floor, and
check if it sits stable as every Adjusting Screw is
touching the floor perfectly.
If not, adjust the length of the Adjusting Screw then
tighten the lock nut firmly by a 13mm spanner.
This is very important to keep enough stability while
your bike is on the stand.
13mm spanner
3
Assemble the clamp jaw unit to the Upper Pillar.
Put the Clamp Shaft through the hole and hold it with
the Back Knob and a flat washer.
The knob should be tightened as firmly as possible until
the clamp jaws rotates smoothly.
4
Insert the assembled Upper Pillar into the Lower Frame
until the bottom cut-outs catch the Upper Pillar Holding
Bolt, then tighten the Lock Bolt firmly by a 5mm hex
wrench.
If you don't tighten the Lock Bolt, the Upper Frame will
be removed suddenly when you lift up the W-3100 by
grabing the Upper Frame.
To install the optional Tool Tray, insert the tray into the
Upper Frame
BEFORE connecting the frames.
Fix the position, then tighten the small knob bolt.
Lock Bolt
Cut-out on Pillar
Upper Pillar Holding Bolt
Tool Tray
Knob Bolt