MINOURA 971-3H - Manual (Page 2)

1
2
3
!
!
5
- 2 -
How To Assemble 971-3H
Required Tools
1 x Phillips Screwdriver (#2)
2 x 13mm Socsket Wrench
First of all, check all small parts are correctly prepared.
Parts List
2 x Base Frame 8 x Round Head Screw M5x40
3 x Stair Frame 9 x Hex Head Bolt M8x35
2 x Pillar-S (792mm) 12 x Hex Head Bolt M8x45
2 x Pillar-M (1,042mm) 15 x Metal Collar (short)
2 x Pillar-M (1,292mm) 6 x Metal Collar (long)
4 x Joint Frame 8 x M5 Spring Washer
3 x B.B. Support 21 x M8 Spring Washer
6 x Tire Cradle 21 x M8 Flat Washer
4 x Foot Adjuster 6 x M8 Nut
Assemble 2 sets of Side Frame.
At first, connect Pillar (1,292mm) and Pillar (1,042mm)
with Joint Frame. Make sure you attach Joint Frame to
the tube end hole on Pillar (1,042mm).
Then connect Pillar (792mm) to this assembly.
Pillar
(1,292mm)
Joint Frame
Pillar
(1,042mm)
Pillar
(792mm)
M5x40 Screw
M5 Spring Washer
Do not miss the direction of Pillar (1,042mm).
Failure causes a problem that the pillars won't
align.
Assemble Base Frame with each Side Frame.
Install Foot Adjusters on both ends of Base Frame.
The larger hole on Base Frame must be downward.
To avpoid stain to the floor or carpet, put
the supplied round transparent film on each
back of Foot Adjuster.
Foot Adjuster
Base Frame
Collar (long)
M8 Flat Washer
M8 Spring Washer
Hex Bolt M8x45
Install Stair Frames on the pillars.
Set all frames in the same direction if you wish to set the
bikes in same direction.
Stair Frame
Hex Bolt M8x45
M8 Spring Washer
M8 Flat Washer
Collar (short)
!
Make sure there are two (2) holes on each Stair
Frame for mounting Bottom Bracket Support.
To set the bike heading right, place Stair Frame
to have the holes in left side.