MINOURA DS-4100 - Manual (Page 2)

Parts Name & Assembling Your DS-4100
Supplied Parts
Cap Bolt M8x45 ... 4
Cap Bolt M8x50 ... 2
M8 Nut ... 6
M8 Spring Washer ... 6
Required Tools : M5 Hex Wrench, 13mm Spanner
First, place the
front tire on the
front side of the
Cradle, then push
the wheel forward
to place the wheel
between the
frames.
The Tire Holder
will raise up
automatically, and
then support the
wheel stable with
3 points.
How To Use Wheel Cradle How To Install Wheel Cradle
1
2
3
Wheel Cradle is pre-assembled. Disassemble it.
Sandwich the Side Frame with both Upper and
Lower Plates. Place the Angle Adjust Plate on
it. Put the M8x60 Bolt with M8 Flat Washer and
tighten to the Lower Plate temporalily.
Put the welded bolt on the Cradle to the Upper
Plate, Collar, Lower Plate, Flat and Washer then
tighten to the M8 Nut.
4
The Cradles is angle adjustable in order to save the
total storage space.
Change the angle then tighten the bolt and nut
equally.
To change the angle again, loosen the nut. Do not
force to turn.
Set the side with shorter
welding inward.
Bar is just inserted into the
hole. Not fixed.
Set the hole inward. M8 Nut
M8 Spring Washer
M8x45 Bolt
Side Frame
Pillar
Rear Tire Guard Bar
Leg
M8 Nut
M8 Spring Washer
M8x50 Bolt
Foot Adjuster
Adjust the length correctly. Turn to adjust the
length, then tighten the nut toward the Leg to fix.
Cradle
Tire Holder
Angle Adjust
Plate
Upper Plate
Lower Plate
Collar
M8x60 Bolt
M8 Nut
M8 Flat Washer
Wheel Cradle
No hole on outside
!
The cradle's inner
width is 66mm.
It's not expandable.
5
Make sure both Upper and Lower Plates are
parallel and tightly touch the Side Frame, and also
the Cradle fits the Upper Plate without any gap,
then tighten M8x60 Bolt firmly.
M8 Flat Washer
Front Side
Foreside