MINOURA Bike Cradle 3 - Manual (Page 2)

Each arm is angle adjustable in +/- 35 degrees in order
to fit various types of bike frames as perfectly as possible
(see Fig. F).
To change the arm angle, loosen the center Arm
Connecting Bolt first (see Fig. G), loosen the backside
screw behind each arm (see Fig. H), then change the
!
It's not recommended that both arms
are set above horizontal level for safety
reason.
You should set the arm which supports
the load mainly at lower than horizontal.
!
Do not put the bike on the cradle while
the arms are not securely fixed yet.
The arms will come closer due to the
bike weight and may fall off the bike.
Tighten the bolts firmly.
4
Rotate the Pivot-Pin to align the thread
hole in the body to the hole on the right
side of the clamp.
Screw the Clamp Tightening Bolt to the
Pivot-Pin (see Fig. E).
To fix the Clamp Band,
tighten the Clamp Tightening
Bolt first, then tighten
the Pivot-Pin Fixing Bolt.
Failure to do so will cause
the clamp to be in the
incorrect position.
!
Contact
MINOURA North America
(for U.S. residents only)
Hayward, California, U.S.A.
Phone 1-510-538-8599 / Fax 1-510-538-5899
[email protected]
MINOURA Jaapn Headquarters
(for ALL customers)
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone +81-584-27-3131 / Fax +81-584-27-7505
[email protected]
www.minoura.jp
Made in Japan
If you have any question or request, please contact the
shop where you originally purchased this product first
or the distributor in your country. The distributor name
can be found on our web site.
Only when you cannot get enough service from them,
you can contact us;
Arm Angle Adjustment
(Fig. E)
(Fig. F)
(Fig. G)
(Fig. H)
angle by hand.
After fixing the arm angle,
tighten those bolts securely.
Warranty
It's your duty to check the following points regularly to
avoid any possible accidents and troubles.
• Check if every part doesn't have any damage or crack
• Check if all screws are tightened securely
• Check if the hook surface is not damaged
Minoura is not responsible to any trouble or accidents
caused by the lack of above checking, the user's
misuse, unauthorized modification, or natural wear.
Warranty Period = 1 year