MINOURA Wheel Display Attachment 3 - Manual (Page 2)

- 2 -
Turn the Pivot Pin to align the
thread hole and the hole on the
clamp body.
Screw the Clamp Tightening
Screw into the Pivot Pin.
Contact
MINOURA North America
(for U.S. residents only)
Hayward, California, U.S.A.
Phone 1-510-538-8599 / Fax 1-510-538-5899
[email protected]
MINOURA Japan Headquarters
(for ALL customers)
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone +81-584-27-3131 / Fax +81-584-27-7505
[email protected] / www.minoura.jp
Made in Japan
If you need help, contact the shop you originally
purchased this product first, or the distributor in
your country. The distributor information is found on
Minoura web site.
When you cannot get any good service from them,
you can contact us directly.
4
To fix the clamp finally,
1) tighten the Clamp
Tighteninig Screw first,
then
2) tighten the Pivot Pin
Fixing Screw.
5
①
②
Using WA-3
!
Wrong procedure
cannot hold the
clamp firmly and
it's dangerous.
The arm angle is adjustable
in 4 positions by changing
the lock pin position.
! Max Load = 4 kgs
Required Tools:
1 x M4 Hex Wrench / 1 x 10mm Spanner