MINOURA GravityStand2 User Manual

Page 2

- 2 -

Join Upper Pillar with

the installed metal plate

nuts. Make sure the square

holes on Upper Pillar align

correctly.

Tighten the M6x12 bolts

firmly.

Lower Pillar

Upper

Pillar

M6x12 Bolt

Install Cradle Base in the

preferred spot.

Hook both ends into the

square holes then slide down

to lock into place.

The lower hook is intentio-

nally wider than the hole

width and acts as a spring to

hold the cradle stably.

Cradle Base

Push the plastic Lock Lever

toward the pillar to lock

Cradle Base position.

To change Cradle Base

position, pull back Lock

Lever then pull out the

cradle.

Lock Lever

Use a flat screw-driver

to release Lock Lever.

Do NOT do with your

finger, otherwise your

nail may be damaged.

Assemble Bike Cradle.

Angle Adjust Plate

Cradle Bar

Cradle Hook

M6x14 Bolt

M6x20 Bolt

Flat & Spring

Washers

Set Angle Adjust Plate with the

long hole facing down. Cradle

Hook must be installed from the

back of Cradle Bar to prevent

possible scratching or marring of

your frame.

Bike cradle is angle adjustable to fit

to your bike's top-tube angle.

Loosen the lower bolt (long hole

side) to adjust. After that tighten

the bolt firmly.

The bike should be set as hori-

zontal as possible.

Set and lean GravityStand to the

wall.

The pillar must be set parallel to

the wall so the bottom side will be

wider for increased stability.

Put the top-tube of your bike on

Cradle Hooks gently.

The stand should be in

contact directly with the

floor or carpet. Do not put

anything between the stand

and floor that might cause

the stand to slip.

Each position and angle of Cradle

Hook is also adjustable.

IMPORTANT NOTES

• GravityStand is only for holding

normal 2-wheel bikes. Do not use for

any other purposes than instructed.

• GravityStand is free standing. It is not

fixed or supported. Be careful not to

hit or bump the stand when passing.

• GravityStand is designed to

absorb normal contact. But we do

recommend using the supplied strap

to provide greater stability.

• Remove any sand and dust from the

area Leg touches to prevent slippage

problem. Do not place paper or

sheet under the leg.

• The hook may stain lighter colored

frames. We suggest wrapping the

hook in bar tape to prevent any

cosmetic damage from happening.

• Check to make sure the bolts on the

stand are tight. Tighten firmly with

the proper tools when needed.

• Minoura offers

1-year limited

warranty from the date of your

purchase. Any problem caused by

manufacturer's defect and wrong

workmanship will be covered by this

program. But any trouble caused

by user's misuse, unapproved

modification, natural calamity and

every problem happened during

shipment will NOT be covered by

Minoura.

For more detail, please refer the

attached "Warranty Program

Instruction" card and Minoura's web

site.

FOR MORE INFORMATION

If you have any quetion, contact

the shop where you purchased or the

distributor in your country first.

The distributor information can be

found on Minoura's web site.

MINOURA JAPAN
1197-1 Godo, Anpachi, Gifu 503-2305
Phone +81-584-27-3131
Fax +81-584-27-7505
Mail [email protected]
Web www.minoura.jp

Made in Japan

Push