MINOURA MoZ-Roller - Manual (Page 4)

How To Assemble MOZ-Roller
1
Take out the Frames from the package, then distinguish the direction.
The right side frame has Lock Lever to prevent unexpected folding, but any other points are same on both sides. (Fig.A)
The left side hole size is always larger than right side one on either Frame. It's not a wrong parts.
[Left Side Frame] [Right Side Frame]
2
There is no specific direction on Roller Drum. It's symmetric. All three rollers are exactly same.
Put Flat Washer to the left side axle to protect the bearing, then insert to the smaller hole on the left side frame.
3
Insert Metal Collar, Flat Washer and Spring Washer from outside of the frame, then tighten Dome Nut temporally.
Repeat it for two other rollers.
4
Put the Roller-Belt on Front and Mid Frames.
(If you bend the frame like Z-shape, the later job can be done easily)
If you will install the optional Mag unit, put the V-belt through Rear Roller. If not necessary, remove it to avoid
unexpected jamming problem.
Required Tools: 17mm Spanner, Phillips Screwdriver
5
Put Flat Washer and Metal Collar to the opposite side axle first, then insert to the larger hole on the right side frame.
Put Flat Washer and Spring Washer to the axle, then tighten Dome Nut temporally.
6
(Fig.A)
Install Bridge Frame between the back of Front Frames with the supplied 4 bolts. (see Fig. B)
At this moment, make sure that Bridge Frame comes through Roller-Belt, otherwise it will confrict the belt when opening
the frame.
The bracket may sit in wrong position in the frame tubing. If you don't find the bracket, lift up and incline the frame to
slide the bracket.
Lock Lever is located on right side
frame only
- 4 -
(Fig.B)