MCZ Club HYDRO 15 kW - Manual (Page 6)

PELLET STOVES Chapter 1
INSTALLATION AND USE MANUAL page 6
Warnings and guarantee conciliations Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
and electricity supply and provision for discharging
combustion gases.
 If there is a fire in the flue pipe, extinguish the
stove, disconnect it from the power supply and
never open the door. Then contact the competent
authorities.
 If the stove and the ceramic cladding are in storage, it
should be in a place that is free of damp, and they
should not be exposed to extremes of temperature.
 It is inadvisable to base the stove directly on the floor,
and if the floor is made of flammable material, it must
be suitably insulated.
 Do not light the stove with flammable materials
if the ignition system breaks down.
INFORMATION
 In case of any problems, get in touch with your
dealer, or a qualified engineer authorised by
MCZ, and if a repair is necessary, insist on the
use of original spare parts.
 Use only the fuel recommended by MCZ (for Italy
pellets with a diameter of 6 mm and for other
European countries with a diameter of 6-8 mm) and
provided only with an automatic supply system.
 Periodically check and clean the smoke outlet ducts
(connection to the flue pipe).
 Accumulated unburnt pellets in the burner after
repeated failed ignitions must be removed before
lighting.
 The pellet stove is not a cooking appliance.
 Always keep the cover of the fuel hopper closed.
 Keep this instruction manual carefully because it
must stay with the stove throughout its working life.
If the stove is sold or transferred to another user,
always make sure that the booklet goes with the
product.
 If it gets lost, ask MCZ or your authorised dealer for
another copy.
1.3. WARNINGS FOR THE CORRECT DISPOSAL OF
THE PRODUCT
The owner is the sole party responsible for demolishing and disposing of
the product. This must be performed in compliance with laws related to
safety and environmental protection in force in his/her country.
At the end of its working life, the product must not be disposed of as
urban waste.
It must be taken to a special differentiated waste collection centre set
up by the local authorities or to a retailer that provides this service.
Separating and recycling prevents potential negative effects on the
environment and health (often caused by inappropriately disposing of
product parts). It also allows materials to be recovered in order to
obtain significant savings in energy and resources.