MCZ Club HYDRO 15 kW - Manual (Page 44)

PELLET STOVES Chapter 3
INSTALLATION AND USE MANUAL page 44
Installation and assembly Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
3.7. INSTALLATION OF AIR FILTER
Before placing the stove near the wall for connection to the flue
pipe and to the electrical mains, install the air filter provided
with the stove.
The cylindrical filter is composed of a metallic net and is already
installed on the stove
The filter must be inserted on the air inlet pipe Ø 5 cm.
To remove it, slightly loosen the screw with the knob on the air inlet,
insert the filter matching it with the filter groove with the screw of the
knob and then secure it by tightening the knob.
ATTENTION!
Never operate the stove without the air filter. Please
ensure this is serviced each year to prevent any
blockage of air flow to the appliance. MCZ shall not be
held liable for damage to internal components if this
instruction is not followed.
3.8. OPENING/CLOSING THE DOOR
The door is opened with the hook on the door, which must be lifted
using the cool hand provided.
WARNING!
In order for the stove to operate correctly, it is
essential that the door be closed completely.
3.9. MAKING THE ELECTRICAL CONNECTIONS
Connect the supply cable first at the rear of the stove and then to an
electrical outlet on the wall.
The main switch located on the rear of the stove should be switched on
only when you want to light the stove.
If you do not intend to use the stove, it is advisable to
keep it switched off.
Electrical connection of the stove
Installation/removal of air filter
Opening/closing the door